Re: {Chrysler 300} Axle bearing shims needed for 300F

["'dave mason' via Chrysler 300 Club International" <chrysler-300-club-international@xxxxxxxxxxxxxxxx>]

Hi Randy,

I’m trying to confirm if the same shim was used during all the sixties.  I have used Napa number 55032 shims for 64.  I called Napa and they show that as being good for 1961-1989.  Not sure why 1960 would be different but I haven’t gotten into this yet for 1960.

To install races, I use a brass drift.  It’s like an inch or so diameter.  If using that, you can go slowly and gently tap around the race until it starts.   Too much at once and it will pop out the opposite side. 
D&K

Sent from my iPhone

> On Dec 9, 2024, at 16:31, 'Randal Edison' via Chrysler 300 Club International <chrysler-300-club-international@xxxxxxxxxxxxxxxx> wrote:
> 

-- 
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
--- 
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/B4AA5A9E-15BF-4170-ACB8-4A097A23726B%40yahoo.com.