Re: {Chrysler 300} 3614S parts

["'ALLAN POZDOL' via Chrysler 300 Club International" <chrysler-300-club-international@xxxxxxxxxxxxxxxx>]

Well, to narrow it down I looking for a better than I have step up rod and three step piston set up. Part #16-217   One rod is pretty worn; needle has a flat spot across the two top steps, and the piston is pretty galled all around. I would look at the both if you have two.

 

Plus I need the accelerator pump rod the connects from the throttle plate to the pump fulcrum.

On 06/01/2026 12:07 PM CDT 'ALLAN POZDOL' via Chrysler 300 Club International <chrysler-300-club-international@xxxxxxxxxxxxxxxx> wrote:

 

 

Does anyone have a 64 K carb 3614S that they are parting out?

 

Allan

 

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/1109765099.262140.1780333677647%40connect.xfinity.com.

-- 
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
--- 
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/190809059.265511.1780341330377%40connect.xfinity.com.