Fw: [Chrysler300] One good turn deserves another!!

["BRUCE NAIMY" <brucenaimy@xxxx>]

----- Original Message ----- 
From: BRUCE NAIMY 
To: Wayne Graefen 
Cc: CHRYSLER 300 CLUB 
Sent: Saturday, November 09, 2002 11:32 AM
Subject: Re: [Chrysler300] One good turn deserves another!!


Wayne,
My unmolested 69 Dodge W100 pickup with 30,000. original miles (of which I have put all of them on) has the left hand theaded lugs on the left hand (drivers) side.No one has touched the brakes since it left the factory.
Hope this helps.
Bruce Naimy
----- Original Message ----- 
From: Wayne Graefen 
To: Undisclosed-Recipient:; 
Sent: Saturday, November 09, 2002 9:48 AM
Subject: [Chrysler300] One good turn deserves another!!


Okay, so you are a new Chrysler 300 or other older Mopar owner and you are going to rotate tires or check your brakes. You haven't owned an old Mop in a while and sometime in this cars history, it has ended up with left and right threaded lugs at opposite corners of the car.

On which side did Chrysler put the left hand threaded lugs and on which the right threaded?

Park Waldrop called with that question this morning and you know, I couldn't give him the answer off the top of my head (pre-morning coffee)!!! Went out to the barn and looked at the F and ingrained in my mind that :

LEFT IS LEFT

RIGHT IS RIGHT

Seems obvious, but if you had a car with swapped around drums, and tried to figure out the engineering principles, would you come up with the same answer??

Wayne






[Non-text portions of this message have been removed]


To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm 

To unsubscribe from this group, send an email to:
Chrysler300-unsubscribe@xxxxxxxxxxxxxxx



Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. 



[Non-text portions of this message have been removed]