Re: [Chrysler300] '65 ball joints

[<smopar@xxxx>]

> You might want to try Just Suspension as they claim to use Moog parts. Were yours from Kanter? If so, I have wondered about them as a club member a few years back said they admitted they obtained theirs from overseas. I hear PST also has these parts, but do not know if they claim they are US made. Just Suspension is usually higher priced than PST, but not sure if that is indicative of anything or not.
Steve Albu 
> From: <Fnnutz@xxxx>
> Date: 2004/01/19 Mon PM 03:19:10 EST
> To: <chrysler300@xxxxxxxxxxxxxxx>
> Subject: [Chrysler300] '65 ball joints
> 
> Hi folks,
> Can anyone please direct me to a source for new arm and ball joint packages for my '65 NY'er( same as 300L)? I replaced both sides about 3 yrs ago with new parts, from a well known seller of suspension parts in NJ. The new right side ball joint was too sloppy after 10000 miles to pass inspection, so I put the 'old' one back on. Now, the left side had bit the dust, after about 15000 miles. I tried NAPA, but no dice. These parts are # 2525450 (right) and # 2525451 (left).
> Maximum axial play according to the service manual should not exceed .050". These near new ones have near a quarter inch of slop! Allegedly made in Canada.
> Any leads appreciated ......
> Dave in New Zealand.
> 
> 
> To send a message to this group, send an email to:
> Chrysler300@xxxxxxxxxxxxxxx
> 
> For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm 
> 
> Yahoo! Groups Links
> 
> To visit your group on the web, go to:
> http://groups.yahoo.com/group/Chrysler300/
> 
> To unsubscribe from this group, send an email to:
> Chrysler300-unsubscribe@xxxxxxxxxxxxxxx
> 
> Your use of Yahoo! Groups is subject to:
> http://docs.yahoo.com/info/terms/ 
> 
> 
>