Hi 300 Group, Spring is here in Northern Minnesota, Back in the garage to finish the G. Need some help about "trim" on the Door panels. In my Gary Goers 300 G Upholstery Kit there are three pieces of piping / cording. The Black piece of cording is about 6' long and of smaller diameter than the tan cording There are 2 pieces of tan cording, each about 3' long and of a bit larger diameter than the black. Does one or both of these ( black or tan cording ) go " on the front door panels." The door panels have the upholstery installed, but looks a little "bare." I didn't send the cording to the upholstery shop when they were done (found them later). Would the black cording go along the seam between the 3 " tan window top edge and the center tan material ( A length of about a 10" from the back edge of the door to the black arm rest dip ). And then continue from the front of the door handle area to the front edge of the door panel. (about 10") Any ideas about the tan cording??? Where does it go? Just forget about it? Thanks for any help in this matter. Lauren R Lampi Grand Rapids, Minnesota 300 G Still under construction but getting closer. [Non-text portions of this message have been removed] To send a message to this group, send an email to: Chrysler300@xxxxxxxxxxxxxxx For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm For archives go to http://www.forwardlook.net/300-archive/ Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Chrysler300/ <*> Your email settings: Individual Email | Traditional <*> To change settings online go to: http://groups.yahoo.com/group/Chrysler300/join (Yahoo! ID required) <*> To change settings via email: mailto:Chrysler300-digest@xxxxxxxxxxxxxxx mailto:Chrysler300-fullfeatured@xxxxxxxxxxxxxxx <*> To unsubscribe from this group, send an email to: Chrysler300-unsubscribe@xxxxxxxxxxxxxxx <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/