[Chrysler300] Horn Relay...Final Chapter

[JettLarry@xxxxxxx]

After about 46 of you pointed out where the relay was hiding, I removed it,  
found the ground plug not pushed into the ground holder but the horn still  
sometimes didn't honk.  After bidding $15 for a new one on eBAY, I took the  old 
one apart.  No one should EVER have to buy a new horn relay.  They  come 
apart with a needle nose in 45 seconds, it takes that much time again to  slip a 
bit of very fine grit sand paper between the points and then another 45  
seconds to use your "Dremel" to clean up the blades on the outside.  Works  as good 
as new.  Hope somebody not reading this note bids higher than the  $15.  
Toodles to all



**************Get trade secrets for amazing burgers. Watch "Cooking with 
Tyler Florence" on AOL Food.      
(http://food.aol.com/tyler-florence?video=4&?NCID=aolfod00030000000002)


[Non-text portions of this message have been removed]


------------------------------------

To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Chrysler300/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/Chrysler300/join
    (Yahoo! ID required)

<*> To change settings via email:
    mailto:Chrysler300-digest@xxxxxxxxxxxxxxx 
    mailto:Chrysler300-fullfeatured@xxxxxxxxxxxxxxx

<*> To unsubscribe from this group, send an email to:
    Chrysler300-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/