To those in the know: Is this same system employed on the 331 hemi in our 1955 C-300? The rear main is leaking and I'd like to seal it. I see the service manual just shows dropping the pan and rear main bearing cap and replacing the lower half of the seal with a special tool with the same OD as the shaft OD. The manual says don't worry about the upper half as it seldom gives problems. 80K miles on the car. Any special materials, sealers or mechanic's tricks to recommend here? Source for the asbestos or whatever rope seal and pan gasket? C-300'ly, Rich Barber Brentwood, CA 1955 C-300 (irritating and messy drips from tranny shifter arm and rear main) -----Original Message----- From: Chrysler300@xxxxxxxxxxxxxxx [mailto:Chrysler300@xxxxxxxxxxxxxxx] On Behalf Of david dumais Sent: Thursday, July 17, 2008 6:00 PM To: chrysler 300 Subject: [Chrysler300] rear main seal The rear main seal was installed per the Felpro tech guy's instructions. The RTV was in the seal slot, and the two "pipe cleaners" were inserted into the RTV, and the black glue was made flush to the saddle edge. The rear main seal was left 3/8" out of the upper slot, and the opposing side was slid up 3/8 to butt up inside the saddle. Bolts were lightly tightened to let RTV cure for 24 hrs. The results will hopefully be kind. I believe John's finless G was bought from a Dr in R.I. that we met in Mystic,Conn. The Gentleman cut off the fins so he could walk around it in his small garage without being bruised. D.E.DUMAIS [Non-text portions of this message have been removed] ------------------------------------ To send a message to this group, send an email to: Chrysler300@xxxxxxxxxxxxxxx For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm For archives go to http://www.forwardlook.net/300-archive/Yahoo! Groups Links ------------------------------------ To send a message to this group, send an email to: Chrysler300@xxxxxxxxxxxxxxx For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm For archives go to http://www.forwardlook.net/300-archive/Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Chrysler300/ <*> Your email settings: Individual Email | Traditional <*> To change settings online go to: http://groups.yahoo.com/group/Chrysler300/join (Yahoo! ID required) <*> To change settings via email: mailto:Chrysler300-digest@xxxxxxxxxxxxxxx mailto:Chrysler300-fullfeatured@xxxxxxxxxxxxxxx <*> To unsubscribe from this group, send an email to: Chrysler300-unsubscribe@xxxxxxxxxxxxxxx <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/