Re: [Chrysler300] 1958 300D Engine Oil Filller Cap

["Richard Osborne reomotorsports1@xxxxxx [Chrysler300]" <Chrysler300-noreply@xxxxxxxxxxxxxxx>]

I used 3M Scotch Brite pads on mine over 10 years ago. I cut the pad into strips so I could stuff the strips into the holes in the bottom of the cap. Seems to still be fine.

Richard

On Jul 21, 2014, at 12:18 PM, Larry Jabin larry@xxxxxxxxxx [Chrysler300] <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:

I am cleaning up & painting an old Oil Filler Cap, the one that has OIL stamped on it twice

 

I have removed all the filtering material inside of it because it was falling apart, took a while to get it all out through the little holes on the bottom

Did not want to take it apart because I thought I might ruin it

 

Not sure what it was made out of, maybe Horse Hair

 

Just trying to figure what I could put in there for a filter without tearing it apart at the seam

 

Thinking about stuffing cotton balls in there

 

Any suggestions would be much appreciated

 

 

Thank You

 

Larry Jabin

 

 

Larry@xxxxxxxxxx

 

__._,_.___

---

Posted by: Richard Osborne <reomotorsports1@xxxxxx>

---

To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to http://autos.groups.yahoo.com/group/Chrysler300/join and select the "Leave Group" button

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang

Visit Your Group

• Privacy • Unsubscribe • Terms of Use

__,_._,___