|
The 1964 Parts and Service manuals don’t seem to show any supports for the exhaust system other than at the muffler’s outlets and at the end of the tailpipe. Apparently, the supports at the rear of the mufflers are attached to brackets fastened to the bottom of the floor pan. If additional supports are common, are there any details on best practice and location? Supports similar to those at the rear of the mufflers could be added to reinforce and support the joints at the muffler inlets. Provision for thermal growth and engine oscillations and vibrations would be required. 1959-1962 ram-engine exhaust and header pipes had varying degrees of support between the exhaust manifolds and the muffler inlets. It would appear that Chrysler engineers felt that the big cast-iron exhaust headers on the J & K engines would adequately support the front end of the exhaust system. A glance at the ’70 hemi exhaust system shows the first support is also at the mufflers’ outlets. That said, I’m having to deal with a ram-K exhaust header with one of the four bolt holes torn out. There was not that much “meat” around the bolt holes. No telling how it was damaged but it looks like an installation or removal error. Rich Barber Brentwood CA (rainy & warm) 1964 300K Ram Convertible From: Chrysler300@xxxxxxxxxxxxxxx [mailto:Chrysler300@xxxxxxxxxxxxxxx] On Behalf Of Anna F Noia sa-noia@xxxxxxxxxxx [Chrysler300] Dave, 300 List The long exhaust manifolds for the Short long ram, require support to hold up the exhaust pipe. If installing the pipe without proper support, the four bolt flange at the connection can break, from what I've heard somewhat easily. Can anyone send a picture of these supports for the exhaust / tailpipe "Installed", and possibly a dimensioned sketch, with mounting points. Any assistance is Greatly appreciated! I think this question fits in this "64 Tailpipe brackets" string, Thanks again! Best Regards, On Sunday, February 5, 2017 12:03 PM, "Dave Dumais dave.dumais@xxxxxxxxx [Chrysler300]" <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote: Thanks for all the support on the K tail pipe hangers. I found them as B body, the rubber straps need to measure up to your pipe. From Accurate Exhaust, in the state of Oregon. And this is the last I'll say about them. Thanks again, Dave in VA. __._,_.___ Posted by: "Rich Barber" <c300@xxxxxxx> To send a message to this group, send an email to: Chrysler300@xxxxxxxxxxxxxxx To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or go to https://groups.yahoo.com/neo/groups/all/manage/edit For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang __,_._,___ |
Back to the Home of the Forward Look Network
Archive Sitemap