RE: [Chrysler300] 300-F brake problems -
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [Chrysler300] 300-F brake problems -





Noel -
 
Your brake hoses may be the problem. Even if they look fine on the outside, they may be collapsing on the inside. I would replace them and see if that solves the problem. Use quality, name brand parts.
 
Ron


From: Chrysler300@xxxxxxxxxxxxxxx [mailto:Chrysler300@xxxxxxxxxxxxxxx] On Behalf Of Noel Hastalis cpaviper@xxxxxxxxxxx [Chrysler300]
Sent: Sunday, July 30, 2017 4:44 PM
To: chrysler300@xxxxxxxxxxxxxxx
Subject: [Chrysler300] 300-F brake problems -

Hello Group,


Hi Everyone,


Welcoming your thoughts on recent braking issues my F is suffering -


Problems started last Sunday afternoon, on my 77 mile drive back home from the Belvidere, IL Mopar Happening. About halfway home, I smelled a brake shoe burning smell, and saw the engine temp gauge move up to the midway point, from its typical cool position - this while running at 70 mph with 90 degree outside temps. The brakes were clearly making contact. The brake pedal was also sitting an inch or more higher than normal, with a hard feel, but the brakes still stopped the car when applied. I backed into my garage, and noticed my brake lights stayed on, even when not touching the pedal. When I lifted up on the pedal, the brake lights would go off. I popped off the hubcaps, all 4 of which were very hot to the touch, to let the wheels cool off a little quicker. When the car cooled down, it was back to normal.


This week, I went to 3 local cruise nights, each about 15 minutes away, with no apparent braking issues. I also took the F to the local shop I've used for all my undercarriage work. They tried to replicate the issue, but couldn't. They cleaned up the front shoes and drums a bit, but said all looked fine.


Yesterday, I drove the F up to Kenosha, WI, to check out the AMC reunion show, and visit with John Begian and his freshly restored '68 AMX. No issues driving the 72 miles up, in the cool morning air. Same issue as last week, however, on the way home. When traffic bottled up on I-294 near O'Hare, the brakes started grabbing, and the engine temp headed higher. I pulled over at the O'Hare Oasis, let the car cool down for 40 minutes, and then drove home with no further issues.


John Begian suggested that I try pulling the vacuum hose off the brake booster, before shutting off the engine, to see if that released the pedal. So this afternoon, I went out cruising again to heat up the car, and got the brakes to grab again, with the smell of brake linings, and engine temp climbing. Brake lights again stayed on when I was out of the car, and the pedal was high and hard. I pulled off the vacuum hose, as John suggested, and heard a whoosh of air, but no change in the high pedal height, and the brake lights still stayed on. The front right hubcap was the hottest, with right rear and left front also pretty warm. Left rear was cool.


Some added background on this car -

I'm thinking it's the brake booster causing these issues, but not sure. My mechanical knowledge is weak, at best!


I welcome your thoughts!


Noel Hastalis

Burr Ridge, IL

F coupe





__._,_.___

Posted by: "Ron Waters" <ronbo97@xxxxxxxxxxx>


To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to https://groups.yahoo.com/neo/groups/all/manage/edit

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang




Visit Your Group
Yahoo! Groups
PrivacyUnsubscribeTerms of Use

__,_._,___


Home Back to the Home of the Forward Look Network Archive Sitemap


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.