Hi Doug, I have a ’63 300 Conv. The rear springs were sagging. I brought it to a local shop that works on school buses and dump trucks. They said they could help me. They used the existing 6 leafs, but added one more leaf to make it similar to the 300J, at my request. Now I have 7 leaves and standard shocks. They also installed all new rubber pads between the leafs. It went from sagging to actually being slightly higher in the back. When I looked at the car, there was a tilt in the back (L to R or R to L). I told him that I would like the rear bumper to look straight. He took the car inside, adjusted the torsion bar, and everything looked perfect. Initially, I don’t think they touched the torsion bars ( I don’t know for sure), but a slight adjustment on one side or the other and everything has been good for probably 15+ years. Maybe this is worth a try? I doubt the springs are sagging since the ones on my car are 55 years old. Did they put in new pads between the leafs? I would recommend the 7 leafs. It is a much stiffer ride and better for cornering. Regards, Mark Lindahl ’63 300 Conv From: Chrysler300@xxxxxxxxxxxxxxx [mailto:Chrysler300@xxxxxxxxxxxxxxx] On Behalf Of 2HsandaHeritage@xxxxxxxxxxx [Chrysler300] HI Group, I installed new Eaton springs and KYB shocks on my 62 Sport conv. 2&1/2 years ago. Rear of car was raised about 1 inch and then completely level. Now left rear is 1 inch lower than right rear. Right spring has a slight upward arc and left spring is flat or has a slight downward arc. Should this have happened in just 2&1/2 years and less than 1,000 miles driven? Any thoughts will be appreciated. Doug Warrener __._,_.___ Posted by: "Mark Lindahl" <MPLindahl@xxxxxxxxxxxxx> To send a message to this group, send an email to: Chrysler300@xxxxxxxxxxxxxxx To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or go to https://groups.yahoo.com/neo/groups/all/manage/edit For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang __,_._,___ |