Re: [Chrysler300] Eaton Springs

["Keith Boonstra kboonstra@xxxxxxxxxxxx [Chrysler300]" <Chrysler300-noreply@xxxxxxxxxxxxxxx>]

Also, your floor is probably not level, so a measurement from wheel opening down to lift might be more accurate and therefore meaningful than the measurement down to the floor.

Keith

-

On Fri, Dec 8, 2017 at 1:05 PM, 2HsandaHeritage@xxxxxxxxxxx [Chrysler300] <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:

 

Hi Group,

Finally had time to place car on my lift and inspect the springs.

Springs seem to be ok - no difference between left and right - no broken leaves.

Removed newer KYB's and took 4 measurements on each side: front and rear Eaton spring attachment bolts from floor, floor to bottom of wheel opening over centerline of wheel and floor to bumper crease over outside bumper bolt.

The 4 measurements average 3/4'' lower on the left side.

Can torsion bar adjustment account for this??

Doug Warrener

__._,_.___

---

Posted by: Keith Boonstra <kboonstra@xxxxxxxxxxxx>

---

To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to https://groups.yahoo.com/neo/groups/all/manage/edit

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang

Visit Your Group

• New Members 1

• Privacy • Unsubscribe • Terms of Use

__,_._,___