Re: [Chrysler300] 1962 Driveshaft Length(s)

["John Grady jkg@xxxxxxxxxxxxxxxxx [Chrysler300]" <Chrysler300-noreply@xxxxxxxxxxxxxxx>]

All a good reason to buy one new from Denny’s . See club site, how to measure . Dump the trunnion joint too . Unless you like vibration at 65 ... J 

Sent from my iPhone not by choice 

On 12 Jun 2020, at 9:33 pm, John spiers@xxxxxxxxxxxxxx [Chrysler300] <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:

The 62 Newport driveshaft would work for other 122" wheelbase 62s, but the Newport u-joint is smaller - at least it is on the 63/64s.

John in Florida 

On Fri, Jun 12, 2020 at 9:16 PM, Cox Scooter465@xxxxxxx [Chrysler300]

<Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:

 

New Yorker wagon is long

Wheel base. 300 sport is

A short wheel base car 122 in.

A Newport wagon was short

Wheel base 122 in. So I would

Think you would have to get a

Drive shaft from a a short wheel base car for your sport.

Newport's would probably all

Work.

Bob Haag

On Jun 12, 2020, at 6:25 PM, Matt Allyn allynentertainment@xxxxxxxxx [Chrysler300] <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:

  

I assume that the driveshafts were all made to fit every model Chrysler in 1962; right?

In other words....

- If I were to take my New Yorker Wagon driveshaft...

- Use it as a pattern to have one made for my 300 Sport OR H....

- It would be good to go; right?

Thanks!

Matt Allyn

__._,_.___

---

Posted by: John Grady <jkg@xxxxxxxxxxxxxxxxx>

---

To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to https://groups.yahoo.com/neo/groups/all/manage/edit

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang

Visit Your Group

• Privacy • Unsubscribe • Terms of Use

__,_._,___