Dave: Thanks for the feedback. Its always good to read about a problem solved and the actual nature of the problem. I noted on my map switch that it did not work very well—probably due to a long period of non-use. I gave it a shot of contact cleaner and operated the switch a number of times to loosen it up. I notice the clear map light lens has been roasted a little by the bulb and don’t see anyone reproducing them. Given a modern lens material, it would appear easy to reproduce as just a clear rectangle without the serrations for diffusion. Anyone have a recommendation for a modern plastic that can take the heat? Rich Barber Brentwood CA From: Dave Dumais <dave.dumais@xxxxxxxxx> Rich and Group, The map light is fixed. After tracing wires, all good , and comparing 2 light units , the conclusion is this. The fiber board on actual switch was loose! The fix was re crimping the switch base to upper area around board. Once re crimped, the board is tight to the internal ground. On to next issue. Thanks All, Dave in hot spot VA You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group. To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx. To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/007a01d6b935%24b4ff6510%241efe2f30%24%40ez2.net. |
Back to the Home of the Forward Look Network
Archive Sitemap