Re: {Chrysler 300} Fwd: Slammed door now stuck on '65

Since neither inside nor outside handle will release the latch, I think the problem is likely in the lock mechanism, not the latch itself - especially when you mention that the lock button does not move over its entire travel path.

One idea sounds like something way too easy to actually work - and maybe others would know - but might it possibly free up if you shot a load of WD-40 right down the lock rod? Or maybe even give a long shot of the WD straight into the door lock keyhole. I’m thinking it just might find its way magically down to where the mech is stuck and release it. Little harm, cost, or time lost in trying that anyway.

I don’t have a ‘65, but I think a good place to start sorting it out would be to remove the door panel from the drivers door and examine very carefully what moves to make what happen. Then maybe you can figure out what part needs to be jimmied which way, and with what shape of bar or hook you could go down next to the glass in the passenger door, to get the lock mech to allow the latch mech to work again.

It’s not likely anything is broke. It probably just lost its lube and stuck in a bad position. And to make matters worse, the white lithium “grease” that was originally slathered liberally on every functioning part of the door, lock, and glass mechanisms would have certainly dried out 35 years ago into a state similar to old plaster. Scrape and clean that out wherever you can and re-lube it all with something more permanently pliable like wheel bearing grease - or even lanolin based Fluid Film which never dries out.

On Mon, Jan 18, 2021 at 6:18 PM Ronald Klinczar <rjklinczar@xxxxxxxxx> wrote:

Folks,

My passenger door on my Chrysler 300 always has closed perfectly. Last week, for some reason, it only half way closed. In response, and without thinking, I reopened and slammed it closed.

Forgot about it for the week, and now I find the push button will not engage, the Inside door latch will not open the door, and ⁹the lock button is not fully able to move. The door is stuck closed. Any idea what I should do?

Ron Klinczar
'65 300 in Ice Blue

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/CAHAPk3WYFXRe1gkF0VQ2C839Xyh3Wgtr%3DywMjvmNoK38Fye74A%40mail.gmail.com.