Just found these over a coffee this morning in a service manual diagram. The shifter plate uses four, the blanking plate uses two. Does anyone have one gland nut and washer, along with the four hood phillips 10/24 screws? I could use these right away as I am on hold. Many thanks in advance! Allan From: chrysler-300-club-international@xxxxxxxxxxxxxxxx <chrysler-300-club-international@xxxxxxxxxxxxxxxx> On Behalf Of apozdol@xxxxxxxxxxx I am assembling the dash at long last, and find now the hardware I put in bags doesn’t seem complete. On my K with the console shifter, the LH dash blank panel for the push button delete is next to go in, and the PO had only two screws holding it in place, mismatched as well. The two studs in the inner edge match the threads of this gland nut perfectly, which I found in the console glovebox. Only found the one. So not sure if this is the application, or do tin nuts hold the inner edges in place? Where does this puppy go if not? How’s this for minutia, friends and neighbors! Anyone save their bits from a parts dash? I also still need the four screws for the dash hood bottom cover. Allan -- For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang --- You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group. To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx. To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/00d401d78166%244ccefd80%24e66cf880%24%40comcast.net. |
Back to the Home of the Forward Look Network
Archive Sitemap