{Chrysler 300} 1964 Idle Arm

["'James Douglas' via Chrysler 300 Club International" <chrysler-300-club-international@xxxxxxxxxxxxxxxx>]

Hello,

 

Can someone enlighten me on the idle arm unit? The factory shows a 220-080 as the arm part number for the full size except Imperial.

 

I received, as part of a front end kit, the bushing style and not the bearing style. This car is a documented 98K mile car. I doubt this idle arm was ever changed.

 

Can someone tell me if either I got an assembly line swap of a part (Imperial) or perhaps it was changed at some point.

 

The issue is the bolt will not fit the bushing style. It is smaller in diameter. It fits the holes in the frame fine.

 

See the attached photo for the arm, the factory set up on the right and the replacement on the left.

 

Thanks, James

 

-- 
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
--- 
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/MN0PR19MB6165A4293EE69FC9DFD912C8932E9%40MN0PR19MB6165.namprd19.prod.outlook.com.