{Chrysler 300} VIn Plate

["'James Douglas' via Chrysler 300 Club International" <chrysler-300-club-international@xxxxxxxxxxxxxxxx>]

I was working on the 300K the other day and my boot caught the plate on the driver’s side door pillar.  It came clean off. The factory spot welds were not too deep on this one.

 

So, since I do not have a spot welder, how would one put it back on.  There are alignment holes in the door pillar as well as the plate. In fact the assembly manual shows to line up the holes and spot weld it just below on the inside of the holes.

 

My thoughts are:

 

1. Glue it down.
2. Screw it down.
3. Use type “U” (round head) drive screws.

 

Anyone want to chime in?  James.

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/CY5PR19MB6171B03A1C9089C750A1B4BB930E2%40CY5PR19MB6171.namprd19.prod.outlook.com.