{Chrysler 300} Re: 300K distributor curve chart

["'ALLAN POZDOL' via Chrysler 300 Club International" <chrysler-300-club-international@xxxxxxxxxxxxxxxx>]

Thanks Bob,

 

Yes I did find this info online. My question is has anyone seen a logarithmic chart for the curve through the RPM range for the 64K.

 

The factory gives a range at certain RPM increments, but this does not give the ideal data points. Plus with a range, it will show a pretty fat line. Kind of shotgunning. 

 

And with only certain datum points, there would not be a representative curve. Just a straight fat line between the RPM markers.

 

 

On 03/09/2025 7:31 PM CDT ALLAN POZDOL <apozdol@xxxxxxxxxxx> wrote:

 

 

Has anyone had their distributor restored and blueprinted, and have a curve chart to share? Or a factory chart?

 

I would like to dial this in, as I assume that the factory had a distinct curve in practice to squeeze 360 HP out of a single carb 413 for 1964.

 

The service manual only gives a range of degrees at a set RPM.

 

Thanks!

 

Allan

-- 
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
--- 
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/1802781951.3230571.1741625180786%40connect.xfinity.com.