Re: {Chrysler 300} F long ram

Are you talking about the aluminum parts that were sawn out of the intake manifolds and go in the valley? If so, no, you will still get exhaust out of the ports in the heads. Plus you can't really torque down the bolts for the intakes properly without those in place.

On Sun, Apr 27, 2025 at 9:55 AM Rick Gould <rdg123@xxxxxxxxx> wrote:

Hi all, I am putting the exhaust back together on the F. I have purchased elbow and heat pipe block off plates to install. Can I run/drive the car after these are installed without installing the intake blocking plates? [I have not removed the cross rams]

Rick Gould

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/CAHuBk%2BMPRsfWhDeihicfpJTpc4YiPfssOo6qj%2Bst4Ki%3DBKNqpg%40mail.gmail.com.