{Chrysler 300} 64 temp sending units

[David Dumais <ddume300@xxxxxxxxx>]

I have 3 sending units that thread into

W/pump housing.

No China or US stamped on any.

1 is stamped 250 with KS j3, 

Another has no stampings.

And one has KS B4 and 250 all stamped

Twice .

All stamping are on hex faces .

Any thoughts on correct unit for the 64

Application?

Also, the voltage regulator stud has the copper ribbon squeezed tightly to it

I have to remove cluster again to verify

It.

I used the 12 volt needle test light between sending unit and the plug on end of violet gauge wire.

It flashed intermittently and not a steady light signal

NOS temp gauge not registering yet.

All pins and board copper have been gently cleaned. 

Any thoughts?

Thanks 

Dave D

Thanks Dave

-- 
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
--- 
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/CAJp4EVFVBiQ3XvU%2B__DO4OZMVJSChJVh1zH%3DrdkiFifaLn%2B7WQ%40mail.gmail.com.