need BB crank pulley

[laborboy@xxxxxxxxxx]

===========================================================
Domains as low as $4.95! 
Limited Time! ICANN Accredited GoDaddy! 
caaccM5b7yoMza/ GoDaddy
===========================================================

I am still looking for a used 4-groove crankshaft pulley for a big block 
engine. One of the members tried to help but the fit was off. The pulley 
is for a '64 383 with power steering and A/C. Here are the measurements 
(as I understand it, later engines have a different width damper, and 
the belt alignment will be off if my pulley is not the same size as the 
old one):

Overall width (back to front): 3 23/32 (or 3.7 inches)

Diameter, Two large grooves in back: 7 3/8 (width of those two: 1 1/4)

Diameter, two small grooves in front: 6 3/8 (width of these two: 1 1/2)

Any help is much appreciated. You may remember that the reason I am 
looking for a new pulley is that my new engine stand failed, and the 
pulley was crushed in the fall (everything else was OK)

Zack

===========================================================
Graduate in less than 13 months with AIU?s Online virtual 
campus. Classrooms and student service as close as your 
computer. Highly accredited, study anytime ? anywhere.
caaccM2b7yoMzf/ AIU
===========================================================



----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 



b7yoMz.