RE: Slip yoke

[Sean B <polecat2@xxxxxxxx>]

When you measure to have a new driveshaft built, they tell you to push 
the slip yoke in all the way, then pull it back out one inch.  Hope that 
helps.

Sean


Dge645b@xxxxxxx wrote:
> 
> 
> Anybody know what the minimal amount of free play the slip yoke
> should have when moving in and out on the output  shaft?


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

bSONJP. 
Or send an email to: 1962to1965mopars-unsubscribe@