Re: Intake poly

[Gary Pavlovich <glpavlovich@xxxxxxx>]

Ed,

The 1956 manifold will be drilled for the approx. 4x4" Square carb pad; 
please send me pictures and I will confirm for you.

By the way, I do have a couple Poly four barrrel intakes available, single 
and dual plane as well as a couple High Performance Camshafts 264/.450" and 
256/.435" solids.

Gary
----- Original Message ----- 
From: "ed keaton" <gtx69@xxxxxxx>
To: "1962to1965mopars" <1962to1965mopars@xxxxxxxxxx>
Sent: Thursday, December 10, 2009 4:20 PM
Subject: Intake poly


> Found intake with casting no 1735919 2x4 was told this is for a 1956 
> plymouth with the poly block.Does anyone know what it fits?I have pictures 
> if anyone wants to see them.
> [Non-text portions of this message have been removed]
>
>
> ----
> Please address private mail -- mail of interest to only one person --  
> directly to that person.  I.e., send parts/car transactions and 
> negotiations as well as other personal messages only to the intended 
> recipient, not to the Clubhouse public address. This practice will protect 
> your privacy, reduce the total volume of mail and fine tune the content 
> signal to Mopar topic.  Thanks!
>
> '62 to '65 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html.


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.