Re: Door Panels

[Blosserde@xxxxxxx]

Thank you. Great instructions
David
Sent from my Verizon Wireless BlackBerry

-----Original Message-----
From: Roger Pettigrew <dodger7998@xxxxxxx>
Date: Wed, 30 Mar 2011 16:09:03 
To: <1962to1965mopars@xxxxxxxxxx>
Reply-To: 1962to1965mopars@xxxxxxxxxx
Subject: Re: Door Panels



no special tools needed, allen wrench for handles, large philips for the  
armrest, and a possible two other screws along top edge of panel,,,,,, remove 
 lock knob and carefully pry out panel from door, some times the spring 
clips in  the panel can be stubborn, just try not to tear them out of the panel 
backing  (pressed cardboard type backing), pull out on bottom, top of panel 
with wiper on  it is hooked into door frame, underneath there should be a 
sheet of plastic that  acts as a moisture barrier for the panel, it is 
secured by a type of sticky  caulk, while your in there be sure to vacuum out the 
bottom of door to get rid  of dirt accumulation from the years of 
service,,,,,,,  
 
 
In a message dated 3/30/2011 2:56:11 P.M. Central Daylight Time,  
Blosserde@xxxxxxx writes:


Is  there any special knowledge needed to removing the interior door 
panels? All  the windows crank up and down very hard and I think it just needs  
lubrication?
Thought I would check with the experienced before I tackle  it
David
1964 Dodge Polara Hdtp
Sent from my Verizon Wireless  BlackBerry


----
Please address private mail -- mail of interest  to only one person -- 
directly to that person.  I.e., send parts/car  transactions and negotiations as 
well as other personal messages only to the  intended recipient, not to the 
Clubhouse public address. This practice will  protect your privacy, reduce 
the total volume of mail and fine tune the  content signal to Mopar topic.  
Thanks!

1962 to 1965 Mopar  Clubhouse Discussion  Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and  
http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.  



--
[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. 




----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

u/?bUrDWg.bSONJP.YXJjLjYy



?p=TEXFOOTER