Re: Poly Stroker Machine Work-1st Steps

["Gary H." <62to65mopar@xxxxxxxxxxx>]

http://www.moparmusclemagazine.com/techarticles/engine/mopp_0309_mopar_engine_rebuild_intro/viewall.html gives a good overview. 

"Is align-honing necessary? Unless there are signs of unusual wear in the old main bearings, the answer is usually no in a basic rebuild....."

Thanks,
Gary H. 
 
>  -------Original Message------- 
>  
>  I'm getting ready to get the machining done to my poly block and I'm a
>  little rusty on everything to do. If I remember correctly, I'll need
>  the following to get the block "ready for assembly"...
>  
>  Hot tank/Degrease
>  Magnaflux
>  Bore & Hone to 3.950" (from 3.910" = .040")
>  Align Hone (do I need to do this??)
>  Clearance for 4" stroker crank (if needed)
>  Install New Cam Bearings
>  
>  Am I missing anything?
>  
>  Bill M
>  65 Coronet 500 'vert http://goo.gl/6xUS1 '''

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.