Re: edlbrock perf carb question

[scott preston <penstarperformance@xxxxxxxxx>]

If you try to install both it will jam,use only the needle and make sure there is not a ball jammed in the circuit,as this happens often.Take the accelerator pump by hand and force the gas through the circuit to test it,to make sure the passage way is not blocked,and test the squirters,mrmopartech

On Thu, Dec 26, 2013 at 6:25 PM, neal zimmerman <neal.zimmerman@xxxxxxxxx> wrote:

Anybody rebuilt an eddy performer  4 bbl recently  enough to remember about the accelerator pump circuit. Edelbrock site says there is a checkball AND a weight  in the passage before the squirters. This is what was in there when I pulled it apart but the squirters wouldn't squirt. Yep I cleared all the passages, pump stroke , etc. Nuthin!! My old Carter afb book shows only a pointed unit ( kind of like a needle) , but no ball.  Could edelbrock site be wrong/ anybody remember?

   neal zimmerman, eugene oregon

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
 
---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/groups/opt_out.

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
 
--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit https://groups.google.com/groups/opt_out.