Re: Window winders

["Gary H." <62to65mopar@xxxxxxxxxxx>]

Thanks!  That looks like an aftermarket tool solution. The factory Chrysler tool that I posted links to is not as fancy. :) 

http://forwardlook.net/forums/forums/get-attachment.asp?action=view&attachmentid=9529

http://forwardlook.net/forums/forums/get-attachment.asp?action=view&attachmentid=9493

Here is a close up of the inside of the handle. 
http://forwardlook.net/forums/forums/get-attachment.asp?action=view&attachmentid=9457

Thanks,
Gary H. 


>  -------Original Message-------
 
>  Steve,
>  
>  Thanks very much for the dimensioned sketch of the bent plate I was looking
>  for. Exactly what I need. I have since found  a picture (no dimensions) of
>  an original tool. It is a good picture because it shows a cross section of
>  the  clip system. I Thought I would post it for interest.
>  
>  Col
>  

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit https://groups.google.com/groups/opt_out.