Re: rings again

[lewtot184@xxxxxxx]

===========================================================
Are you looking for savings on products you use everyday? 
Visit Quality Health today and see the coupons, free 
samples and special offers our members enjoy each and 
everyday.
caab3ozb7yoMza/ Ivo Interactive
===========================================================


i doubt a .005 oversize ring would cause a failure. a lot of race ring sets 
are .005 over fot file fit. having the end gap .003 over won't cause a bunch of 
blow-by(assuming your using a hypereutectic piston). do a cylinder leak down 
test. check for piston to head clearance. most head gasket failures i've seen 
due to head fitting to tight on the locating dowels in the block. make sure 
the heads fit on the dowels easily. i usually loosen up the fit a little with 
aluminum heads.

[Non-text portions of this message have been removed]

===========================================================
**** Bounces like rubber! Shatters like ceramic! ****
Discover Crazy Aaron's Thinking Putty in grown up 
handfuls. It's the creativity unleashing, mood enhancing 
desk toy!
caab4CEb7yoMzf/ Crazy Aaron Enterprises
===========================================================

----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 



b7yoMz.