Re: 413

[Gary Futrell <gary-futrell@xxxxxxxxxxxxx>]

===========================================================
Let University of Phoenix make 2004 your year. Evening, 
weekend or FlexNet® classes ? over 130 locations. Look 
into our programs and get the degree that gets you going!
caaccMPb7yoMza/ UOP
===========================================================





I've bought some rebuilt 906 heads that have had
2.14/1.81 valves installed and the head surface at
least smoothed off, but I don't know if they have been
milled very much. Where would one take a measurement
to determine how much metal has been removed? I was
thinking about milling these heads to increase the
compression ratio, but didn't want to increase the
valve train problems. I suppose .010 would cause very
few problems.

  Gary
 
  


> 
> Well I will jump in here, probably step on my d*($,
> but I would guess that 
> you can go farther than you will want to, if the
> hydralics dont take up the 
> difference, shims under the rocker shaft should.  
> just my 3cw (canadian)
>                                                     
>                    
> dodger
> 
> --
>

===========================================================
Empower your Team with Remote Access. GoToMyPC Pro 
provides your organization with instant remote access to 
email,files, applications and network resources in real 
time. FREE TRIAL:
caaccMSb7yoMzf/ ExpertCity
===========================================================

----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 



b7yoMz.