Re: Pinion seal ?

[for26hemi@xxxxxxx]

[AD removed for archives]
-------------------------------------------------------------------
Did president Bush react quickly enough to hurricane Katrina?
caad3P2bOyW3Na/Nationwide Survey
-------------------------------------------------------------------


Jake,
    Just my opinion, but I would pull the yoke, pull  the seal, pull the 
front bearing cone....insert a bearing shim(maybe about  .020"), then reassemble 
the stack. This should reload the crush sleeve and be  sure to retorque pinion 
nut to spec.If someone on the list has another way to do  this I'm all 
ears...then I can remember this for my rearend work. Be sure to  polish the seal 
surface on the yoke with 400 or 600 grit paper to get rid  of some of the wear 
groove and establish a nice surface for the lip to ride on,  it also goes without 
saying to lube the seal. Good luck, Dan
 
'62 Sport  Fury
'62 Fury wagon
'62 Fury 4-dr.
'68 Coronet Hemi R/T
'69 Super  Bee

[Non-text portions of this message have been removed]

[AD removed for archives]
-------------------------------------------------------------------
Need a new Cell Phone? A BlackBerry 7250 could be yours free! Find 
out how!
caad32RbOyW3Nf/Amazing phone
-------------------------------------------------------------------

----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 



bOyW3N.