Re: Turn Signal/Horn Wire Harness Removal

[HoustonDB@xxxxxxx]

You have to remove the terminals from the plastic connector at the end of  
the harness.  
 
Make a little sketch to show which color wire goes to the different  
positions in the plastic connector.  Release the terminals from the plastic  connector 
and then slowly pull the turn signal cam and wiring out of the  steering 
column.  If you skip down about halfway on the page in the link  below, it has a 
picture and a little information about removing the plastic  connector.
 
_http://www.1962to1965mopar.ornocar.org/ml-houstons-steeringcoupler.html_ 
(http://www.1962to1965mopar.ornocar.org/ml-houstons-steeringcoupler.html) 
 
Hope that helps.....
 
Houston
'64 Belvedere

[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

. 



http://www/?p=