Re: bushing 440 lifter bores

[Donnie Schanz Jr <dcs426@xxxxxxxxxxxxxx>]

Contact Ray Barton Racing engines. They did a 440 stroker engine in a 
magazine a few years ago and explained all the procedures. I called and 
inquired about it and will probably have it done, but I am a ways-off  from 
finishing my car.

Thanks
Donnie
----- Original Message ----- 
From: <garrett.safford@xxxxxxxxxxx>
To: <1962to1965mopars@xxxxxxxxxx>
Sent: Sunday, March 25, 2007 4:55 PM
Subject: bushing 440 lifter bores


> Does anyone have any experience bushing the lifter bores on 440 blocks? 
> Is
> it worth it to have it done?  What are the pros and cons?  Does it 
> increase
> longevity or reliability?
>
> Thanks,
> Garrett Safford
>
>
> ----
> Please address private mail -- mail of interest to only one person --  
> directly to that person.  I.e., send parts/car transactions and 
> negotiations as well as other personal messages only to the intended 
> recipient, not to the Clubhouse public address. This practice will protect 
> your privacy, reduce the total volume of mail and fine tune the content 
> signal to Mopar topic.  Thanks!
>
> '62 to '65 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html.


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.