Re: Manual to auto trans swap

[streetwedg@xxxxxxx]

If you have a steel crank, you must use a unweighted converter.cast cranks have weights on converter. 
 
-----Original Message-----
From: gary.futrell@xxxxxxxxx
To: 1962to1965mopars@xxxxxxxxxx
Sent: Sat, 14 Apr 2007 5:45 PM
Subject: Re: Manual to auto trans swap


That's right, replace the flywheel with a flexplate which bolts to the 
torque converter. 
 
  Gary 
 
 
On 4/14/07, Bill Provins <wiilbill66@xxxxxxx> wrote: 
> 
> 
> This may be a stupid question, but when switching from a manual to an 
> automatic trans, do you just have to pull off the flywheel and bolt on a flex 
> plate? Of course all the other parts, cooler, cable, shifter. There isn't any 
> issues with the crank is there? 
> Wylde Bill 
> 
> 
> 
________________________________________________________________________
AOL now offers free email to everyone.  Find out more about what's free from AOL at AOL.com.

[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.