RE: Rear end yoke

[mcwheels@xxxxxxxxxxxx]

The info you're looking for should be in this article.  Dan

http://www.autohobbydigest.com/8_75.html



ledman_70@xxxxxxxxxxx wrote:
> 
> On the subject of yokes...I just installed a new set of Richmond 3:91's 
> in the 489 case of my 64 Polara, and Summit sent me a pinion with a 
> coarse spline while the 3:23's I removed had fine splines. I had to use 
> my old yoke, which was smaller, so I need to change u-joints now, of 
> course. I can't remember the part number from the last rear end swap I 
> did, but I know there's a joint that measures around 3.3" by 3.6" to go 
> from the small yoke to the larger, later year slip-joint drive 
> shaft...anybody remember the part number? 
> 
> Douglas J wrote:
> > 
> > 
> > >From: moparbikeguy@xxxxxxx
> > >9 1/4 and 8 3/4 yokes are different and won't interchange.
> > >'65 Coronet 500 stroker
> > >
> > 
> > Ok.  I was going by the information in the tech archives on the 62 to 65 
> > 
> > 
> > home page.  Says the splines are the same and interchange.  Are you 
> > saying 
> > the 9 1/4 yoke uses yet another size u-joint ?
> > 
> > Jake
> > '63 Sport Fury 'vert
> > 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.