Re: Rear drums

[sky62 <sky62@xxxxxxxxxxxxx>]

yeah, and the puller, was bolted to 4 of the lugs (the lugs were  
press fit into to the drums from behind).
so pulling on the lugs helps pulling the drum off.
then center the center piece, of the puller, on the axle and snug it  
up tight.
 (mine has a big wing nut you can strike with a sledge hammer)
strike it a couple times and wait a few min. and strike it again and  
wait for it to pop.
WD40, or the like, helps also.
 I think you can rent these pullers and I've seen them at swap-meets  
too.

Schuyler 62 Dodge Dart 440 wagon w/ Poly 318
 <http://www.1962to1965mopar.ornocar.org/ml-wrobel62.html>
FYI - I Do the Decal designs for the Poly head 318 and more! email me  
with your needs -
 <sky62@xxxxxxxxxxxxx>



On Sep 5, 2007, at 10:33 AM, Richard Kinsley wrote:

> WiilBill66@xxxxxxx wrote:
> > I need a little help from everyone out there. I want to pull off the
> > rear
> > drums to check out the brakes. I've heard about using a puller,  
> > but from
> > what
> > I've read, it looks like that is to pull the axle. Do you have to  
> > pull
> > the axle
> >  to pull the drum off, or am I wrong. I'd rather not pull the axle  
> > if I
> >  can
> > help  it. Any help is appreciated.
> > Thanks,
> > Wylde Bill
> =====================================================================
>
> Now I'm assuming you do have an early tapered axle. In which case you
> will have a big nut on the end of the axle. The drum is kinda pressed
> onto the axle end and the puller attaches to the wheel and pulls the
> drum off the axle like the harmonic dampner off the crank. You have to
> remove the nut and cotter pin from the end of the axle of course. It's
> rarely easy to do but with much persistence and helpful languauge
> assaults you will get it done.
>
>
> Rich Kinsley  '64 Polara 4 dr 318poly w/goodies
>
>
> ----
> Please address private mail -- mail of interest to only one person  
> -- directly to that person.  I.e., send parts/car transactions and  
> negotiations as well as other personal messages only to the  
> intended recipient, not to the Clubhouse public address. This  
> practice will protect your privacy, reduce the total volume of mail  
> and fine tune the content signal to Mopar topic.  Thanks!
>
> '62 to '65 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html.


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.