B body drivetrain into A body

[moparbikeguy@xxxxxxx]

After changing to the A body engine mounts and exhaust manifolds, I finally have been able to install my original 273 and 904 from my '65 Coronet into my '65 Dart. I had to modify the crossmember in order to accept the trans mount and while I was at it, I also modified it to accept dual exhaust. It appears that the A body 904 must have a different tailshaft (shorter) because I will never be able to hook up the speedo cable because of chassis interference. 

Is there a plug available to fill the hole? I was think about a welsh (freeze) plug.

My B body downshift linkage won't fit the tight engine bay either. Anybody have any kuck with the cable operated downshift linkages available?

I was also able to install all of my spare Coronet front brake setup, giving me much better brakes. All I had to purchase was Upper A arms for a late disk brake A body (1975) and everything including upper and lower balljoints bolted on.









'65 Coronet 500 stroker


________________________________________________________________________
Check Out the new free AIM(R) Mail -- Unlimited storage and industry-leading spam and email virus protection.

[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.