64 BB 4 Speed Conversion/ Milodon 31010 Pan

[Nico Over <nover@xxxxxxxx>]

Hi all, been awhile since I last posted but am seeing the light at the end of
the tunnel on my 64 SF restification. I have come up with a problem though and
need some info. The through the firewall clutch rod is about 4 inches to
short. I purchased a complete B body pedal assembly which included all the
pieces and am surprised that I can't hook up the Z bar without having the
clutch pedal about 4 inches below the brake pedal. Could someone please
measure their clutch rod and give me the length. Maybe I have an A body rod?
Also I installed the Milodon 31010 oil pan it fits beautifully but since I was
installing th engine and trans together I had to notch the passenger side of
the K member to get it in. After it was in I can see where if one was
installing just the engine it would fit without having to any notching. Would
be tight but will work. Lastly the Schumacher headers are the easiest headers
I have ever worked with, they just drop in. Hope this helps!
Nico Over
Va. Beach, Va
64 SF 451 4 speed
63 Dodge 440 wagon


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.