RE: Mixed up valves

[Sean B <polecat2@xxxxxxxx>]

Thanks, Scott

Sean


Scott Powell wrote:
> 
> Well, if the guides aren't in the budget at this time, check each valve
> in the guides and try to match them to the least possible worn guides.
> You should be able to find an automotive machine shop to install bronze
> guide liners for about 10 to 15 bucks a guide.  Take a flat file to the
> keeper groove area to eliminate any small burrs from the grooves as this
> will facilitate putting the valve in the guides easier and prevent
> damage to the guide.  When checking for guide wear, be sure to have the
> valve in the area of travel when checking for slop.  Good Luck.


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.