RE: 4 speed hump

[george smith <bt6t4@xxxxxxxxx>]

I was going to mark my 4 spd. hump tomorrow and cut
the hole app. the size of the hump itself.That was the
advice given me.seems a bit radical to cut that much
out and weaken the floor. How big should the opening
be?
--- Dave Walters <whdavid@xxxxxxxxx> wrote:

> 
> 
> Brian Schlump wrote:
> > 
> > Galen decoded my car for the previous owner and
> his report shows that it 
> > 
> > was a factory 426 street wedge with a 4 speed. 
> One of the things that 
> > always amazed me is the crude hole in the floor
> above the transmission.  
> > 
> > It looks like someone at the factory took a torch
> and blew a hole in the 
> > 
> > hump in the floorboard, and then welded on the 4
> speed hump.  Is that 
> > typical of a factory 4 speed installation?  It
> sure looks crappy.  
> > BTW....The previous owner did replace some of the
> floorboards, but not 
> > in that area above the transmission....Brian
> > 
> > '64 Belvedere
> > Davenport, Iowa
> > 
> > "The difference between ordinary and extraordinary
> is that little 
> > extra."
> 
> Yep,that's how it was done.You might take the
> opportunity now to clean 
> it up a bit while the tranny is out-if you prefer a
> cleaner look that 
> is.
> 
>   Dave Walters
>   Denver, Co.
> 
>   
> 
> 
> ----
> Please address private mail -- mail of interest to
> only one person -- directly to that person.  I.e.,
> send parts/car transactions and negotiations as well
> as other personal messages only to the intended
> recipient, not to the Clubhouse public address. This
> practice will protect your privacy, reduce the total
> volume of mail and fine tune the content signal to
> Mopar topic.  Thanks!
> 
> '62 to '65 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html. 
>
> 
> 


George


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.