Re: idler arm

[MrChristopher1@xxxxxxxxxxx]

I have used both techniques.  The 3 arm puller, if you have one would be my first choice, BUT like George I had to use a pickle fork, BFH and I applied some heat to it with a torch.  I get the pickle fork set, keep hammer hany, get the arm pretty hot, then...WHACK!  Popped right off...Make sure it doesn't land on your foot...that sucks.
JM2C...
--Christopher
'64 Dodge 440 2 Dr. Hard Top 
'87 Dodge Ramcharger 
'00 Merc Berz C230 Kompressor 16.73 1/4 - (Hey, It's DaimlerChrysler)

-------------- Original message -------------- 
From: george smith <bt6t4@xxxxxxxxx> 

> 
> Jack up the front end to take the pressure off the 
> idler arm. Use a pickle fork and a BFH. 
> --- Richard wrote: 
> 
> > 
> > 
> > hi, am in the process of replacing some worn out 
> > parts on the steering/front suspension on my 63 
> > dodge. am having trouble convincing the idler arm to 
> > let go. my natural intincts are screaming "use a 
> > bigger hammer". how much force can you put on the 
> > arm without damaging something else, such as the 
> > inner tie rod end, or bend the link?should both 
> > front wheels be off the ground? any advice much 
> > appreciated, thankyou, richard. [oz] 
> > [Non-text portions of this message have been 
> > removed] 
> > 
> > 
> > ---- 
> > Please address private mail -- mail of interest to 
> > only one person -- directly to that person. I.e., 
> > send parts/car transactions and negotiations as well 
> > as other personal messages only to the intended 
> > recipient, not to the Clubhouse public address. This 
> > practice will protect your privacy, reduce the total 
> > volume of mail and fine tune the content signal to 
> > Mopar topic. Thanks! 
> > 
> > '62 to '65 Mopar Clubhouse Discussion Guidelines: 
> > http://www.1962to1965mopar.ornocar.org/mletiq.html. 
> > 
> > 
> > 
> > 
> 
> 
> George 
> 
> 
> 
> 
> ________________________________________________________________________________ 
> ____ 
> Never miss a thing. Make Yahoo your home page. 
> http://www.yahoo.com/r/hs 
> 
> 
> ---- 
> Please address private mail -- mail of interest to only one person -- directly 
> to that person. I.e., send parts/car transactions and negotiations as well as 
> other personal messages only to the intended recipient, not to the Clubhouse 
> public address. This practice will protect your privacy, reduce the total volume 
> of mail and fine tune the content signal to Mopar topic. Thanks! 
> 
> '62 to '65 Mopar Clubhouse Discussion Guidelines: 
> http://www.1962to1965mopar.ornocar.org/mletiq.html. 
> 
--
[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.