Re: 8 3/4 Pinion Seal Replacement?

[Gary <mopar413@xxxxxxxxxxx>]

That is all there is to it. Just be sure to retighten the pinion nut .  
---- "Dennis C." <dennis.2914@xxxxxxxxx> wrote: 
> 
> I just bought a 1965 complete 8 3/4 differential for my 63 SF.  I want 
> to change the pinion seal before I put it in the car.  Is this as simple 
> as pulling the U-Joint yoke, replacing the seal and replacing the yoke?  
> I am concerned that pulling the yoke will change the pinion / ring gear 
> setup.
> 
> Any help would be appreciated.
> 
> Dennis C.
> 
> 
> ----
> Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!
> 
> '62 to '65 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html. 
> 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.