Re: 318 Eddy Performer manifold questions

[Bill <Y1TopBanana73@xxxxxxxxx>]

You will have to make a little bending modification to your linkage
bracket (which you'll figure out easily) and you'll have to extend
your kickdown linkage if I remember correctly. I ended up finding an
extra one, cut the sleeve and threaded rod part off, and added them
together to get the linkage long enough...it worked just fine.

Bill M
65 Coronet 500 'vert

On Sat, May 17, 2008 at 10:10 AM, neal zimmerman
<neal.zimmerman@xxxxxxxxx> wrote:
> Hi gang,  sorry,  this is a  little off topic, but still Mopar.  I
> went ahead  and  bought that 1967 cuda i was  talking about a couple
> months  ago.   It has a 318 2bbl in it.
>   I  found  a 318 edelbrock performer 4bbl  manifold for it, and i
> have a  small   Carter
>   ( edelbrock) AFB.
>  I am wondering about hookup.  since its not that tall of a manifold
> will the  old stock linkage work or do i need to  modify.
>  thanks
>    neal zimmerman, eugene oregon
>