RE: RANDYS RING AND PINION 8 3/4 GEAR NOISE

["Earl H. " <earlh@xxxxxxxxxxxxxx>]

Robert,

This is a personal opinion, based on personal experience. Randy's is 
the worst in my book. I would never purchase from them. I did a couple 
of times, and each experience was painful. I would suggest finding a good 
driveshaft/rear end/old school garage in town, and have them look at it.
Perhaps 
they can see something wrong, perhaps not. I have had a couple that I could 
never get all the noise out of. 

Earl

Hi all,

I purchased a complete clutch posi, 3.55  8 3/4 unit from Randys Ring and
pinion.
Very unhappy with the product and they dont seem to care. The ring gear is
very noisy from 1800 rpm up. I pulled the unit back out and it looks good.
Rears and gears are not my specialty.   

oil     80-90 wgt
posi additive


Any ideas???

Robert
 63 spt fury conv
63 spt fury http
--
[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person --
directly to that person.  I.e., send parts/car transactions and negotiations
as well as other personal messages only to the intended recipient, not to
the Clubhouse public address. This practice will protect your privacy,
reduce the total volume of mail and fine tune the content signal to Mopar
topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.