RE: 383 Intake Gaskets

[Sean B <polecat2@xxxxxxxx>]

I've tried to use gaskets with this pan on 440's a couple of times, and 
couldn't get the intake bolt holes to line up correctly.  I ditched them 
in favor of the valley pan only, and had success.

Sean


Dennis C. wrote:
> 
> I'm going to be pulling the intake on my 63 SF.  I have a new intake 
> gasket set, it has the pan and a set of gaskets. I believe I've seen the 
> intake manifolds installed with just the metal pan.  Am I correct and if 
> so is there a good way to know when gaskets  should be installed along 
> with the pan?


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.