RE: a little help please

["Robert (UK)" <r.lane@xxxxxxxxxx>]

Hi Jack
My brother found a pair (or was it 4? I'll check...) of freshly restored 
crimson arm rests for our 63 earlier this year. I think it was from a 
vendor that sells on ebay.
I'll check where they were from if you still need a supplier. They were 
pretty good and didnt cost the earth, if I remember correctly.

We also asked Just Dashes about our dash pad (which has a couple of 
cracks), but they DID cost the earth, so didnt bother in the end.

By the way, we also got our door panels from SMS and were very pleased, 
on the whole. Only problem being they were about 6mm, sorry 1/4" too 
long so we needed to peel back the vinyl and trim the card so the doors 
would shut against the new rubber weatherstrip!

I'll dig out some pics of the arm rests if needed. Let me know.

Cheers!

Robert
63 Polara 500
England

Jack Cheek wrote:
> 
> 
> hi all
> im redoing a 63 polara 500 hard top.going with a 440 bored .030 over 
> with a max wedge top end.
> im in need of some information on how i might get the pad redone on the 
> dash as  well as the arm rest .any help with that would be apprecated.i 
> had door panels redone by sms and they turned out very nice ,as i had 
> the seats already done.i forget what the white is called but the red is 
> crimson red
> 
> thanks jack


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.