Re: Pistons?

[Herb <zephyr9900@xxxxxxxxxxx>]

If it's not broke why fix it?  Sounds like worst case scenario is new rings.
 Just my II.

Herb 
 
-------Original Message-------
 
From: MO ( Steve Mick)
Date: 02/01/09 22:13:03
To: 1962to1965mopars@xxxxxxxxxx
Subject: Pistons?
 
My 413 engine doesn't appear to have any ring groove- I had considered
boring to 426, but would rather not at this time. Problem is finding 413
pistons -so far the choice is  having custom  made  forged pistons, or
Sealed Power still offers a cast piston, pin, ring kit. ( much less
expensive)  I am planning about 9 1/2 :1 compression with 5500-6000 RPM.
Tops. Might do some occasional drag strip racing, but you know how it is
when you get the pedal to the metal urge . :)  I would welcome anyones
opinion......................................MO.............. SW  IOWA
 
 
[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

u/?bUrDWg.bSONJP.YXJjLjYy



?p=TEXFOOTER