Fuel Pump shield for poly

[Rich Kinsley <rlkinsley@xxxxxxxxx>]

Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies

I looked at the template in our tech section for the fuel pump shield 
and I see the poly shield will need some mods to work. The Metal 
Superstore where I used to get misc metal is out of business so I went 
to Home Depot and found some .019" aliminum sheetmetal. I have a fuel 
pump gasket too. The issue here is that the poly has the dipstick right 
in the way. I'll have to play with it a bit and see what I can do to get 
a shield wrapped around in between the block and dipstick tube. I looked 
at my 440 on the engine stand and I see it doesn't have that issue.

Has anybody done this on their poly? I'll accept suggestions.


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.