RE: carb sealer

["Gary H." <spigot2039@xxxxxxxxxxx>]

Yeah, seems like a pain to take the carb  apart. All the silicone type sealers don't like gas contact,as far as I recall.

What about roughing up the leaky area of the carb to create surface cling, then apply some Permatex 26346 Hi Temperature Metal Repair Compound

http://www.amazon.com/Permatex-26346-Temperature-Repair-Compound/dp/B000ALBZMG

Thanks,
Gary H.

-----Original Message-----
>From: SB 
>Possibly.  It is a fresh rebuild, and the bubbles so tiny, I was hoping 
>to get away without taking it apart.
>
>Thanks, Gary

 wrote:
>> 
>> Can you double up the gasket?
>> 
>> Gary H.
>> 
>> -----Original Message-----
>> >From: SB  
>> >My Carter BBD I just rebuilt has a slight warp, and gas slightly bubbles 
>> >where the top meets the body in the front.  Is there a sealer I could 
>> >smear there to stop this? 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.