RE: Axle
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Axle



I double checked and as far as I can tell the 65 differential did not 
use shims.  There is metal plate on each side along with the foam 
gaskets however it is not like the tappered axles that uses a shim pack.

I agree it could be a thrust block issue however it could also be that 
the axle is too long for the 3rd member.

My concern is that if the axles are too long or the thrust block is not 
seated properly it will not allow the bearings to seat in the cones.  As 
I understand it the adjustment is to properly set the bearing to cone 
clearance.  If additional shims are used at the flange to space the 
axles out it seems to me that it could result in excessive bearing to 
come clearance.

If I am looking at this all wrong please let me know.

Thanks
Dennis C.

mopar413@xxxxxxxxxxx wrote:
> 
> First make sure that the thrust block is in correctly.  Then just start 
> adding shims to the housing. One on each side until you have slack. You 
> should not have very much.  I adjust mine untill I can barely feel it 
> move.  Be sure to thump the opposite side each time you adjust it.    It 
> sounds like you have the thrust block that has a little dowl like affair 
> on the end and it is not entering the gear housing just right. Just take 
> a real good look and see what type you have.



1996 Dodge Ram 3500 Van Conversion
1964 Plymouth Belvedere 318 Auto
1963 Plymouth Sport Fury 383 4-speed
1949 Dodge Pickup 289/C4 soon to be changed
1998 Honda Valkyrie Standard


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 












Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.